AirLive SNMP-FSH2602MG - Manual (Page 25)

AirLive SNMP-FSH2602MG User’s Manual
13
Station Port LEDs for Port 1 ~ 24
The SNMP-FSH2602MG is equipped with 2 LEDs on the sides of each RJ-45 station port.
This design allows users to view the status of each port quickly. The left LED indicates the
Link/Action Status. The right LED indicates whether the connection is in 100Mbps mode
Link/Act LED
Link/Act LED giving a solid green light indicates that a data link has been established
between the corresponding port and the device. If no connection is made, it will be off.
While the port is transmitting or receiving data, you will see a blinking green light.
100M
100M LED giving a solid green light indicates that a 100Mbps data link has been
established between the corresponding port and the device. If a 10Mbps connection or no
connection is made, it will be off.
Gigabit Port LEDs
The Figure below shows the switch equipped with a 2-port 1000Base-T Modules. It has 2
LED indicators for each port.
Link LED
When the top LED remain solid green, it indicates a 1000Mbps connection has been made
ACT LED
While the port is transmitting or receiving data, you will see a blinking green light.
LED Table
LED indicator Color Status Meaning
System LEDs
Power LED
DIAG LED ● Green
● Red
ON
OFF
Blinking
ON Power ON
Power OFF
Performing Self-Diagnostic Test
Diagnostic Test is successful
Station Port LEDs
Link/Act ● Green ON
Blinking
OFF
Connection Established
Transmitting/Receiving
No connection is made
100M ● Green ON
OFF
100 Mbps Connection
10 Mbps Connection
Gigabit port LED
Top LED
Bottom LED
● Green
● Green
ON
Blinking 1000Mbps Connection
Transmitting/Receiving
Table 3-1 LED Table