AirLive SNMP-FSH2602MG - Manual (Page 24)

AirLive SNMP-FSH2602MG User’s Manual
12
3
LED Indicators
Before connecting any network device to SNMP-FSH2602MG, you should take a few
minutes to look over this chapter and get familiar with the front panel LED indicators of your
Switch.
Comprehensive LEDs
The front-panel LED indicators of SNMP-FSH2602MG comprise 3 sets of LEDs: System
Status LEDs, Station Port LEDs, and Gigabit port LEDs. Each set of LEDs gives specific
information concerning the system status or the station port status:
Fig. 3-1 front-panel LED indicators
The specific function of each LED will be described in full details in the following sections:
System LEDs
Power LED
The Power LED will give a solid green light when you turn on the Switch, and will be off
when the Switch being turned off. You can simply check the Power LED to see if the
Switch is being activated. Before turning on the Switch, please verify that the power cord
has been properly connected to the Switch and the power outlet on the wall.
DIAG LED
The DIAG LED indicator will blink for 100 seconds during power-up to indicate the process
of diagnostic test. During the Diagnostic test, the switch will not function and all the ports
are not available. Once the self-diagnostic test is completed, the DIAG LED will remain
solid green. The switch will function normally after the process is completed.
Station Port LEDs
System LEDs Gigabit port LEDs