AirLive SNMP-FSH2602MG - Manual (Page 15)

AirLive SNMP-FSH2602MG User’s Manual
3
“192.168.223.100 in Web browser or Telnet program to manage the switch.
If users can’t find the switch at the default IP address, please connect the switch to the
console port. Use the console port management to change the switch’s IP
configuration.
Console Port Information
Please use a serial cable to connect between the console port of the switch and the
COM port of the computer.
Use a terminal program such as Window’s Hyper terminal
Open a new session and select the right COM port. Then enter the connection
information as followed:
Bits Rate per Second = 57600
Data Bits = 8
Parity = None
Stop Bit = 1
Flow Control = None
Please “enter” key to get into the smart console
Please note the smart console will not work during the 100second Power-On test.
User’s Name and Password
The Default User’s name and Password is as followed
User’s Name: admin
Password: 123
LED Table
LED indicator Color Status Meaning
System LEDs
Power
DIAG
● Green
● Red
ON
OFF
Blinking
ON Power ON
Power OFF
Performing Self-Diagnostic Test
Diagnostic Test is successful
Station Port LEDs
Link/Act
● Green ON
Blinking
OFF
Connection Established
Transmitting/Receiving
No connection is made
100M ● Green ON
OFF
100 Mbps Connection
10 Mbps Connection
Gigabit port LED
Top LED
Bottom LED
● Green
● Green
ON
Blinking
1000Mbps Connection
Transmitting/Receiving