AiM MyChron3 XG Log - Manual (Page 67)

Transmitting the configuration
It is recommended, before transmitting the configuration, to switch on the
instrument and to connect it to the PC’s USB port.
Once set all the parameters, it is necessary to transmit the configuration to the
instrument.
In order to transmit the configuration, you have to press the Transmit pushbutton
and the system, automatically, will download the configuration from the PC to the
instrument’s Flash memory.
If the data logger is not correctly connected to the PC’s USB port or if the data
logger is switched off when transmitting the configuration, it will appear the
following screenshot on your PC’s monitor:
Please, ensure that the data logger is switched on and correctly connected to the
PC and then retry to transmit the configuration.
Sensors calibration (Gold/Gold XG versions only)
Once the configuration has been transmitted to the instrument, it is absolutely
necessary to autocalibrate the internal lateral g-sensor (or the Gyroscope) and
the “potentiometer distance”, and to calibrate the “mid zero potentiometer”, the
67