AiM MyChron3 XG Log - Manual (Page 28)

To delete the total working time and the distance covered by
the vehicle, please press twice button MEM/OK; press VIEW,
instead, if you do not wish to delete these information.
It is reminded that this function computes only time and
distance corresponding to a single test: if you wish to know
the total distance covered by the vehicle, please run function
“Odometer”.
Odometer This function computes the total distance covered by the
vehicle during all the tests made.
To run this function press button MENU/<< till you see
ODOMETER
Unlike the previous function, this parameter cannot be erased.
Gears
calibration
Your gauge is able both to detect the engaged gear by using
an on-board sensor (for those vehicles equipped with a sensor
installed inside the gearbox) or by calculating them (using an
algorithm based on engine’s RPM and Speed). If no sensor is
installed and the driver does not wish to see the gear number
on the display, the gauge allows the user to disable the gear
channel.
To run this function press button MENU/<< until you see
GEAR CALIBRATION
Press button NEXT/MEM to activate one of the gears
calibration functions here above described:
28