AiM MyChron3 XG Log - Manual (Page 34)

In order to capture the correct wheel’s angular speed, it is
necessary to set the correct teeth number.
To run this function press MENU/<< until you see
PULSES ON WHEEL
Then push MEM/OK to enter EDIT MODE: use button
MENU/<< to change numbers and button >> to change digit.
The blinking digit identifies the digit that can be edited.
This parameter is included between a minimum value of 0 and
a maximum of 199.
Press button MEM/OK to save the changes and button VIEW
to quit without saving.
Max RPM
value
This function sets the maximum scale for the graphical RPM
display and the maximum acceptable RPM value acquired by
your MyChron 3 Plus/Gold/Gold XG.
MyChron 3 Plus/Gold/Gold XG has seven levels for the
RPM scale: 8,000 / 10,000 / 12,000 / 16,000 / 20,000 / 22,000
and 25,000 RPM.
To run this function, after having entered the
CONFIGURATION MODE, push MENU/<< until you see
MAX RPM VALUE
Then push MEM/OK to enter EDIT MODE and use buttons
MENU/<< or >> to scroll between the seven standard RPM
values. When the required RPM value is displayed, press
button MEM/OK to save the changes or button VIEW to quit.
34