Eppendorf TransferMan4 m - Manual (Page 70)

Operation
TransferMan
® 4m
English (EN)
70
6.16.2 Installation parameters
6.16.3 Control board parameters
6.16.4 Joystick parameters
6.16.5 Module parameters
Parameter Value Range of values Increment Standard
Side Set the mounting side LEFT/RIGHT – RIGHT
Angle Set the capillary angle in
degrees 0° – 90° 1 –
Parameter Value Range of values Increment Standard
LCD contrast Set the display contrast 65 % – 75 % 1 70 %
LCD light Set the brightness level of
the display 0 % – 100 % 1 100 %
Beeper Set the volume 0 – 100 % 1 50 %
Display
coordin. Set the coordinate display OFF/ON – On
Parameter Value Range of values Increment Standard
Z Factor Acceleration factor for the
Z-axis relative to the X and
Y-axis 5 % – 400 % 5 100
Dyn-mode Switch the dynamic
movement range on or off OFF/ON – On
Dyn-factor Set the dynamic factor 0 % – 1000 % 1 100 %
Parameter Value Range of values Increment Standard
Invert X-axis Reverse the direction of
movement of the motor OFF/ON – OFF
Invert Y-axis Reverse the direction of
movement of the motor OFF/ON – OFF
Invert Z-axis Reverse the direction of
movement of the motor OFF/ON – OFF
X-axis off Switch the motor of the
movement axis on or off OFF/ON – OFF
Y-axis off Switch the motor of the
movement axis on or off OFF/ON – OFF