1 setting up a network connection, Setting up a network connection – Eppendorf Mastercycler nexus User Manual

Page 80

System management
Mastercycler

nexus

English (EN)

8.7.1

Setting up a network connection

Prerequisites

• Ethernet cable (RJ45, Cat.5), not included in the delivery package
• Logged in as an administrator (see p. 37)

Proceed as follows:

1. Select the

System

Network Settings

node.

2. Press the

Connection

softkey.

The

Network Connection Settings

window appears.

3. To assign the IP address automatically via DHCP, check the

Obtain IP settings automatically via DHCP

checkbox. Alternatively, enter the IP address, subnet mask and standard gateway as specified by your
network administrator.

4. To assign the IP address of the DNS server via DHCP, check the

Obtain DNS settings automatically via

DHCP

checkbox. Alternatively, enter the IP addresses of the DNS servers as specified by your network

administrator.

5. Insert the Ethernet cable into the Ethernet port on the rear of the device and connect it to an Ethernet

port of the Ethernet network.

6. Press the

Set

softkey to accept the settings.