Eppendorf Mastercycler nexus - Manual (Page 73)

System management
Mastercycler ® nexus
English (EN)
73
8.4 Cycler functions
The cycler nodes enable you to view and adjust the status of the thermoblock and the heated lid and
access the protocols of the last 20 programs.
The softkeys have the following functions:
Prop. • Change the name of the cycler node.
The name must not contain any special characters.
• Display the installed firmware version
• Display the last logged-in user
• Display the last run program
Incubate Display and change the current temperature of the heated lid and the thermoblock.
• Current temperature: Display the current temperature
• New temperature: Set the target temperature
• Heat / Incubate : Control the temperature of the heated lid/thermoblock
• Keep settings after power on : Automatically keep the current temperature control
setting when the cycler is idle. This setting will remain unchanged even after a
cycler restart. It can only be changed by an administrator.