Eppendorf Mastercycler nexus - Manual (Page 27)

Installation
Mastercycler ® nexus
English (EN)
27
4 Installation
4.1 Selecting the location
Information regarding the dimensions and weight of device components can be found in a separate section
(see Weight/dimensions on p. 97).
Take the following criteria into account when selecting the location for the Mastercycler nexus:
• The surface must have sufficient bearing capacity and ensure the required stability.
• The surface must be free of vibration.
• The device feet must not slip.
• The height of the location should allow for convenient and safe operation of the device.
WARNING! Risk of injury due to unsuitable work surface.
The device may fall over if placed on an unsuitable work surface.
 Observe the criteria in the operating manual on selecting a location.
NOTICE! Damage from overheating.
 Do not install the device near heat sources (e.g. heating, drying cabinet).
 Do not expose the device to direct sunlight.
 Ensure unobstructed air circulation. Maintain a clearance of at least 30 cm around all
ventilation grilles.
When the device is in operation, ensure that the power switch of the device and the mains
isolating device (e.g. FI safety switch) are accessible.