Eppendorf Mastercycler nexus - Manual (Page 54)

Programming
Mastercycler
® nexus
English (EN)
54
5. Press the Insert softkey.
The program step is inserted with standard parameters.
You can now insert additional program steps or edit the parameters of the program steps.
6.3.2 Editing parameters
1. Mark the desired program step with the arrow keys.
The marked program step is highlighted in blue.
You can change the temperature, holding time and number of cycles directly in this view.
2. Press the enter key to accept the changes.
Extended options
3. Press the Options softkey.
The extended parameter settings for the marked program step are displayed.
Hold Temperature step with adjustable block temperature and indefinite holding time.
The set temperature is maintained until the user presses the enter key. A
corresponding prompt is displayed in the status view and signaled by orange flashing
of the status lamp.
Sound This program step emits an acoustic signal.
Pause As Hold . The block temperature remains set to the value of the previous temperature
step.
Temperature Adjustable from 4.0°C to 99.0°C (in 0.1°C increments)
Dwell time Adjustable from 000:00 to 999:59 (mmm:ss) in 1-second
steps
Number of cycles Adjustable from 1 to 99