Eppendorf Mastercycler nexus - Manual (Page 71)

System management
Mastercycler ® nexus
English (EN)
71
Schedule Settings : Make
schedule settings
Use the Schedule Settings node to configure the schedule view and
selection options.
 Mark the Schedule Settings node. Press the Set softkey.
• Check the Enable Screensaver checkbox to use the schedule as a
screensaver. Set the time after which the screensaver should be
activated in the
Wait [s] field.
• To select the weekdays that should be displayed in the schedule,
check the corresponding boxes for In schedule day view the following
weekdays are displayed .
• To select the device types that should be displayed in the schedule,
check the corresponding boxes for In the schedule editor the following
cyclers are enabled .
 Press the OK softkey.
Service Intervals : Setting
intervals for temperature
verification and self-test
You can determine intervals for a regular temperature verification or
self-test via the
Service Intervals node.
 Mark the Service Intervals node. Press the Verification or Self-test
softkey.You can set the intervals In the following display.
• Specification of months (1 – max. 24)
• Specification of programs run (1 – max. 2000)
The following details are shown on the display for each cycler:
• The programs run since the last verification or self-test
• The date of the next check
You can also find this information under the Block ((see p. 74)) cycler
system functions.
You are informed via an info message before the defined intervals
expire. The info message contains details about the remaining days or
program runs until the interval expires. If email dispatch is activated
((see p. 81)), the administrator receives a corresponding message.
When the intervals expire, a temperature verification or self-test must be
carried out. Alternatively, you can deactivate the interval setting.