Eppendorf Mastercycler nexus - Manual (Page 31)

Installation
Mastercycler ® nexus
English (EN)
31
1. Open the flap (1) to access the USB ports (2).
2. Insert the USB device into one of the two ports.
Newly connected USB devices are automatically detected during operation.
3. Close the flap.
4.2.5 Connecting the eco device
This section explains how to operate one or two eco devices together with a master variant of the
Mastercycler nexus. The eco device is controlled via a master variant Mastercycler nexus. This requires a
cable connection between the devices. Use Eppendorf CAN-bus cables for this (see Accessories on p. 105).
Connecting a single eco device
Abb. 4-2: Wiring diagram showing rear view of the devices
Fig. 4-2: Wiring diagram showing rear view of the devices
Connecting two eco devices
Abb. 4-3: Wiring diagram showing rear view of the devices
Fig. 4-3: Wiring diagram showing rear view of the devices
The connections and switches are located on the rear of the devices.
4.2.5.1 Establishing the data connection
1. Switch off all devices at the power switch.
Connecting the first eco device
2. Connect the CAN bus cable to the CAN out port of the Mastercycler nexus (with control panel) and to
the CAN in port of the eco device.
Connecting the second eco device
3. Connect the second CAN bus cable to the CAN out port of the first eco device and to the CAN in port of
the second eco device.
Eco device 1 Master device
Eco device 2 Eco device 1 Master device