Eppendorf Mastercycler nexus - Manual (Page 32)

Installation
Mastercycler
® nexus
English (EN)
32
4.2.5.2 Setting the Eco and Term switches
You must set the Eco and Term switches on all devices depending on whether you have connected one or
two eco devices to a master variant of the Mastercycler nexus.
 Set the Eco and Term switches on the rear of all connected devices as follows:
4.3 Shut down
Proceed as follows if you do not want to use the Mastercycler nexus for longer than a week.
1. Load the block with an empty PCR plate or tube.
2. Close the heated lid and flip the handle forwards .
3. Disconnect the Mastercycler nexus from the power supply.
Never leave the lid of the Mastercycler nexus open to prevent contamination of the block.
Connected devices Master device Eco device 1 Eco device 2
One eco device — —
Two eco devices
• The position of the Eco switch of the eco device should reflect its installation position on
the left or right next to a master variant of the Mastercycler nexus with control panel.
• If you operate the Mastercycler nexus on its own, the position of the Eco and Term
switches is not important.