Snorkel SR2770 - Manual (Page 73)

G
Gauges
Air Filter, 4-1
Amps, 4-1
Bubble Level, 4-2
Engine Oil, 4-1
Fuel Level, 4-2
Hours, 4-2
Hydraulic Oil Level, 4-2
Water, 4-1
General Specifications, 3-1
Gradeability, 3-1
Ground clearance, 3-1
Guides rollers and slides, 7-6
H
Hazardous Components, 12-1
Antifreeze (UN 1993), 12-1
Battery, Lead/Acid (UN 2794), 12-1
Diesel Fuel (NA 1993), 12-1
Foam In Tires, 12-2
Gasoline (UN 1203), 12-2
Hydraulic Oil (UN 1270), 12-3
Liquefied Petroleum Gas (UN 1075), 12-3
Motor Oil (UN 1270) , 12-4
Hydraulic oil
leaks, 7-4
Hydraulic oil level, 7-4
Hydraulic tank cap, 7-4
I
Inspection
Operators daily inspection, 7-1
Inspection and Maintenance Table, 7-1
Insulation rating, 3-1
L
Lanyard Anchor Points, 11-1
Level sensor, 7-7
Lift time, 3-1
Lifting the SR, 10-3
Lower time, 3-1
M
Maintenance personnel
see Introduction - page iii
Maximum height to basket floor, 3-1
Maximum outreach, 3-1
Maximum outreach height, 3-1
Maximum rated axle capacity, 3-1
Maximum width of base, 3-1
Outriggers retracted, 3-1
Minimum Safe Approach Distance
see Electrical Hazard - page ii
N
Nomenclature and Serial Numbers, 3-3
Nominal working height, 3-1
O
Operating Procedures, 8-1
Bubble Level, 8-9, 8-10
Control Stations, 8-1
Extending the platform, 8-11
Operating From Ground Control Box, 8-2
Operating From Platform Control Box, 8-4
Raising the platform, 8-3, 8-7
Raising the stabilisers, 8-9
Setting the stabilisers, 8-8
Stabilisers, 8-8
Operators
qualified, 7-1
Overall height, 3-1
Overall weight, 3-1
P
Placards and decals
Inspection drawing, 7-11
Standard placards and decals, 7-10
Platform
Guardrails, 7-6
Lanyard anchorages, 7-6
Platform size, 3-1
Pre-start Inspection, 1-1
Pushing, 9-2
Pushing the SR, 10-3
Q
Qualified operators
see Introduction - page iii
R
RCD / ELCB Outlet, 11-1
RCD / ELCB Reset, 7-8
Responsibilities of owners and users
see Introduction - page iv
S
Safe Operation, 1-1
Safe working load (main deck), 3-1
Safe working load (roll out deck), 3-1
index 2 SR2770 – 11669A
Index