Snorkel SR2770 - Manual (Page 53)

❑
Setting the stabilisers manually
Figure 8.28
1. Check to see that the ground under the four
stabiliser pads  (see Figure 8.28) is firm,
stable, and unobstructed.
2. Completely lower the platform  (see Figure
8.28).
3. The engine must be running and the SR set
for platform control box € operation (see
Figure 8.28).
Figure 8.29
4. Set switch ‚ to manual mode (see Figure
8.29).
5. Operate each individual switch ƒ (see
Figure 8.29) one at a time, until all four
stabiliser pads  contact the ground (see
Figure 8.28).
Figure 8.30
6. Visually check the bubble level „ (see
Figure 8.30) to determine which stabilisers
must be further extended to level the
platform  (see Figure 8.28).
NOTE
When the bubble in the bubble level is in the
center of the ring † the platform is level.
7. Lower the appropriate stabilisers just enough
to center the bubble (see Figure 8.30).
When the Lift Indicator Light ‡ (see Figure
8.29) comes on, the platform can be safely
raised.
❑
Raising the stabilisers manually
1. Completely lower the platform.
Figure 8.31
2. Set switch € to manual mode (see Figure
8.31).
3. Operate each individual switch  (see
Figure 8.31) one at a time, until all four
stabilisers are completely up.
page 8 - 10 SR2770 – 11669A
8. Operation
7
6
8