Snorkel SR2770 - Manual (Page 52)

Figure 8.25
3. Visually check the bubble level ƒ to
determine which stabilisers must be further
extended to level the platform  (see Figure
8.25).
NOTE
When the bubble „ in the bubble level is in the
center of the ring , the platform is level.
4. Lower the appropriate stabilisers just enough
to center the bubble ƒ (see Figure 8.25).
When the Lift Indicator Light † (see Figure
8.24) comes on, the platform can be safely
raised.
❑
To raise the stabilisers:
1. Completely lower the platform.
Figure 8.26
2. Push and hold the Stabiliser switches ‡
forward until all the stabilisers are completely
up (see Figure 8.26).
■ Self Levelling Stabilisers (Optional)
For units fit ted with self lev el ling sta bi lis ers the fol -
low ing ap plies.
1. Set switch € to automatic mode (see Figure
8.27).
To raise or lower the sta bi lis ers ‘au to mat i cally’
switch  (see Fig ure 8.27) is used.
2. Press switch  momentarily (3 - 4 seconds
to lower the stabilisers.
The stabilisers will lower and level the
platform automatically.
3. Switch  can also be used to raise the
stabilisers to the stowed position. To do so
press, momentarily, switch  in the raise
direction and all the stabilisers will raise
automatically.
NOTE:
If an alarm sounds whilst in the auto mode it
indicates the machine cannot auto level due to
the terrain conditions.
Figure 8.27
NOTE:
Although this option is designed to automatically
set the stabilisers and level the SRT it is possible
to set the stabilisers manually should this be
desired
SR2770 – 11669A page 8 - 9
8. Operation
6
5
7