Snorkel SR2770 - Manual (Page 20)

MAIN POWER........................ON
EMERGENCY STOP..............on (up)
SELECTOR............................PLATFORM
■ Stabilisers
Figure 2.12 - Stabilisers
The sta bi liser con trols are on the up per left side of
the plat form con trol box. The sta bi lis ers are used to
level the SR (for com plete sta bi liser op er at ing pro -
ce dures see the “Op er a tion” chap ter 8).
NOTE
The SR must be on a firm surface capable of
withstanding all load forces imposed by the aerial
platform in all operation conditions before the
stabilisers are used.
■ RCD/ELCB AC Outlet (option)
Figure 2.13 - RCD/ELCB AC Outlet
The RCD (Residual Current Device) is located at
the ground and will protect against short circuits to
earth. When there is a short circuit the RCD will
shut down the 230v AC power to the platform
outlet. To reset the outlet disconnect the power tool
lead from the platform box and reset the RCD at the
ground. If the problem persists call a trained
service technician.
■ Flashing Light (option)
Figure 2.14 - Flashing Light
The flash ing light alerts peo ple that the SR is pres -
ent and that the SR is mov ing. The light flashes at
about one flash per sec ond any time the SR en gine
is run ning. There is no ON/OFF switch for the flash -
ing light, it can not be turned off while the SR is run -
ning.
■ Lanyard Anchor Points (option)
There are four an chors on the floor of the plat form,
one at the front of the roll-out deck, one at the back
of the plat form, and one on each side of the plat -
form.
NOTE
These anchors are not for lifting or tying down
the machine.
You should at tach your fall pro tec tion to the an -
chors if work rules re quire it.
page 2 - 4 SR2770 – 11669A
2. Safety Devices
RCD
Power Input
Connector
Power Outlet
At Platform