Snorkel SR2770 - Manual (Page 17)

2. Safety Devices
■ Safety Device Information
For emer gency op er a tion con trols and pro ce dures
see the “Emer gency Op er a tion” chap ter 9, in this
man ual.
The de vices listed in this chap ter are safety de -
vices.
They are on an SR to in crease safety in the work
place for both the op er a tor and other peo ple near
the ma chine.
Do not by-pass, disable, modify, or ignore
any of these devices. Check them carefully
at the start of each work shift to see that they
are in working order (see “Daily Inspection &
Maintenance” chapter7). If any is found to be
defective, remove the SR from service
immediately until a qualified service
technician can make repairs.
■ Emergency Stop Switches
❑ At platform control box
Figure 2.1 - Platform Control Box Emergency
Stop Switch
Press the large red EMERGENCY STOP but ton in
and the en tire ma chine stops, the en gine turns off,
and noth ing moves. This switch must be out (on) to
con trol the SR from the plat form (pull the switch
and it will pop out).
❑ At ground control box
Figure 2.2 - Ground Control Box Emergency
Stop Switch
Press the red EMERGENCY STOP switch cover
down, at any time, un der any con di tions, and the
en
tire ma chine stops, the en gine turns off, and
noth ing moves. the EMERGENCY STOP switch
must be up for any thing on the SR to work.
■ Alarms
❑
Platform control box
Figure 2.3 - Platform Control Box Alarm
There are two alarms on an SR. One is lo cated in
the plat form con trol box, the other is lo cated in the
ground con trol box.
SR2770 – 11669A page 2 - 1
WARNING