Stabilisers 8-8, Setting the stabilisers 8-8, Setting the stabilisers, 8-8 – Snorkel SR2770 User Manual
Page 51: Stabilisers, 8-8, Stabilisers, 8-8, 11-1, Stabilisers -8 setting the stabilisers -8, Danger, Operation

To make a nor mal stop, slowly move the Joy stick
Con trol ler to its “cen tered” neu tral po si tion then
re lease it.
3. Squeeze and hold the Safety Control
against the Joystick Controller (see
Figure 8.21).
4. Push the Joystick Controller forward to
raise the platform, or backward to lower it.
The further you push the Joystick
Controller forward, the faster the platform
rises. There is only one down speed.
■ Stabilisers
NOTE:
Using the stabilisers.
The plat form must be fully low ered to en able the
sta bi lis ers to op er ate.
Once the plat form is raised the sta bi lis ers can not
be set or ad justed.
Be fore op er at ing the sta bi lis ers check to see that
the ground con
di
tions un
der the four sta
bi
liser
pads (see Fig ure 8.22) is firm, sta ble and un ob -
structed.
If the platform is up and the ground
compresses unevenly under different
stabiliser pads the SR might fall over
causing serious injury or death. Check the
level bubble frequently during operation. If
any movement of the bubble occurs,
immediately lower the platform and readjust
the stabilisers to re-center the bubble in the
ring.
Death or serious injury can result if an SR
tips over. Do not use the stabilisers to gain
extra working height, they are not designed
for that purpose. At least one of the
stabilisers should raise the SR above the
ground - use the other three to level the SR
as necessary.
When us ing the sta bi lis ers al ways check that all
four are firmly on the ground be fore rais ing the plat -
form.
The SR will not DRIVE un less all four sta bi lis ers
are com pletely raised i.e. If any one of the sta bi lis -
ers is even slightly low ered the DRIVE func tion is
dis abled.
■ Setting the stabilisers
Figure 8.22
1. The engine must be running and the SR set
for platform control box operation (see
Figure 8.22).
Figure 8.24
2. Pull and hold the Stabiliser switches
(see Figure 8.24)backward, one at a time,
until all four stabiliser pads (see Figure
8.23) contact the ground.
page 8 - 8
SR2770 – 11669A
8. Operation
DANGER
DANGER