Snorkel SR2770 - Manual (Page 27)

■ Circuit Breakers
❑
Main breaker
Figure 5.4 - Main Circuit Breaker
There is only one cir cuit breaker, on a stan dard SR,
that is ac ces si ble to the op er a tor. Its pur pose is to
pro tect the elec tri cal cir cuits from elec tri cal over -
loads. When the cir cuit breaker trips (pops out)
push it back in then at tempt to use the SR.
If the cir cuit breaker trips a sec ond time, take the
SR out of ser vice and re fer the prob lem to a qual i -
fied trained ser vice tech ni cian for re pair.
❑
RCD / ELCB outlet (option)
Figure 5.5 - RCD/ELCB Outlet
The RCD (Residual Current Device) is located at
the ground and will protect against short circuits to
earth. When there is a short circuit the RCD will
shut down the 230v AC power to the platform
outlet.
To reset the outlet disconnect the power tool lead
from the platform box and reset the RCD at the
ground.
If the problem persists call a trained service
technician.
page 5 - 2 SR2770 – 11669A
5. Automatic Shut-offs and Circuit Breakers