Snorkel SR2770 - Manual (Page 60)

10. Stowing and Transporting
■ Stowing
At the end of each work day (or in prep a ra tion for
trans port ing, push ing, lift ing, or stor age) a qual i fied
op er a tor should put the SR into its stowed po si tion
then lock it.
The cor rect stowed po si tion is shown here.
Figure 10.1 - Correct Stowed Position
To bring the SR into the Stowed Po si tion use the
con trols on ei ther the ground con trol box  or the
plat form con trol box € to:
1. Fully lower the platform  (see Figure 10.1).
2. For models with stabilisers:
Use the stabiliser controls ‚ to completely
raise all four of the stabilisers ƒ (see Figure
10.1).
3. Close the platform entry gate „ (see Figure
10.1) and close all the doors on the machine.
To lock an SR:
Figure 10.2
1. Push the Emergency Stop switch down
(OFF) and set the Main Power switch † to
OFF then remove the key ‡ (see Figure
10.2).
Figure 10.3
2. Turn the Battery switch ~ OFF and
padlock it (see Figure 10.3).
Figure 10.4
SR2770 – 11669A page 10 - 1