Snorkel SR2770 - Manual (Page 64)

11. Options
This chap ter lists and ex plains all the op tions avail -
able for an SR.
■ RCD / ELCB Outlet
Figure 11.1 - RCD / ELCB Outlet
The RCD (Re sid ual Cur rent De vice) is lo cated at
the ground and will pro tect against short cir cuits to
earth. When there is a short cir cuit the RCD will
shut down the 230v AC power to the plat form out -
let.
To re set the out let dis con nect the power tool lead
from the plat form box and re set the RCD at the
ground.
If the prob lem per sists call a trained ser vice tech ni -
cian.
■ Flashing Light
Figure 11.2 - Flashing Light
The flash ing light alerts peo ple that the SR is pres -
ent and that the SR is mov ing. The light flashes at
about one flash per sec ond any time the SR is run -
ning. There is no ON/OFF switch for the flash ing
light, it can not be turned off while the SR is run ning.
■ Electrical Outlet
Figure 11.3 - Electrical Outlet
The elec tri cal out let on the plat form, and its power
ca ble, are de signed to sup ply 2 kW of con tin u ous
duty power to run power tools of var i ous sorts. The
power can come from ei ther the op tional ac gen er -
a tor, dis cussed else where in this chap ter, or from
an elec tri cal source out side the SR. If you use an
elec tri cal source out side the SR be sure you dis -
con nect it be fore you drive the SR away.
■ Lanyard Anchor Points
There are four an chors on the floor of the plat form,
one at the front of the roll-out deck, one at the back
of the plat form, and one on each side of the plat -
form.
NOTE
These anchors are not for lifting or tying down
the machine.
NOTE
You should attach your fall protection to the
anchors if work rules require it.
SR2770 – 11669A page 11 - 1
RCD
Power Input
Connector
Power Outlet
At Platform