Snorkel XRT33-sn2300+CE - Manual (Page 10)

10 XRT Work Platform
F OLD D OWN G UARDRAILS
NOTE: When performing the following procedures, retain all fasteners.
This procedure is only for passing through doorways. Guardrails must be returned to proper position before using
the machine.
F OLD D OWN P ROCEDURE
1. Ensure that the slide-out deck extension is fully
retracted and deck pin is locked. Place the Platform
Controls on the platform.
2. Pull the pins on the two end gate arms. Lower the rear
gate to the floor. Replace the pins.
3. Pull the pins (2) on the left side of the front rail and
swing the front rail back against the right handrail. Insert
pins into right handrail.
4. Lift the right handrail up, then lower it to the extension
deck floor.
5. Push the deck extension handle into locked position. Lift
the left handrail up, then lower it on top of the right
handrail.
6. Rotate the arms in against the handrails.
7. Lift the right main handrail and lower it to the floor.
8. Lift the left main handrail and lower it on top of the right
main handrail.
E RECTION P ROCEDURE
1. Reverse the fold down procedure.
2. Hang the Platform Controls from front guardrail.
3. Before operating the work platform, check that all fasteners are in place and securely fastened.
W A R N I N G ! !
Before operating the machine, guardrails must be securely fastened in their
proper position.
Deck
Extension
Handle
Figure 7: Fold Down Guardrails
67 XRT Work Platform
XRT27 Labels
5
6
22
7
18
7
7
19
17
7
21
12 11 20 11 12
6
12
11
27
2
51 cm
51 cm
2
33 cm
33 cm
8
2
13
14
9
25
23
1 24
8
10
21
12
11
20
6
16
15
2
26
16
15
4
6
28 29
3
Front
Rear
Power Module Side
Control Module Side
Upper Controller