Class1 ES-Key-USM - Manual (Page 25)

25
MNGT Menu
The [SYS] menu opens a selection window
for information on Load Management, En-
gine or the database file.
Pressing [MNGT] brings up the Load Man-
agement View. The system Load Manage-
ment data is presented. The sequence level,
shed level and system voltage are displayed.
The stage and mode conditions are shown
as well as whether load management is en-
abled or disabled.
SCROLL ESC
Information on load man-
agement, Engine, or data-
base file?
[ENG] [ MNGT ] [FILE]
Using the UP and DOWN arrows results
in a diagnostic mode where the voltage
display is changed by 0.1 VDC per switch
press. The system will act as if this were
the actual system voltage. Range is 10.0
VDC to 13.8 VDC.
SCROLL ESC
There are three Letters that can appear
in the Bottom Right of the display.
H indicates that a High Idle output is ac-
tive.
O means that a High Idle Override input
is active.
L indicates that the system Low Voltage
Alarm is active. to the System Select
Menu.
SCROLL ESC
Information on load man-
agement, Engine, or data-
base file?
[ENG] [ MNGT ] [FILE]
Pressing [ESC] returns you to the System Select Menu.
SCROLL ESC
LOAD MNGT: DISABLED
SEQ:4 SHED:7 STG:OFF
MODE A :Response
VOLTS: 13.8
SCROLL ESC
LOAD MNGT: ENABLED
SEQ:4 SHED:7 STG:ON
MODE B :Scene
VOLTS: 13.8
SCROLL ESC
LOAD MNGT: ENABLED
SEQ:4 SHED:7 STG:ON
MODE B :Scene
FORCE VOLTS: 13.8
LOAD MNGT: ENABLED
SEQ:4 SHED:4 STG:ON
MODE B :Scene
FORCE VOLTS:12.4 HOL