Rockwell Automation 1734-AENT POINT I/O EtherNet/IP Adapter Module - Manual (Page 62)

Publication 1734-UM011D-EN-P - May 2011
46 Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
Set Up the Hardware
In this example, a ControlLogix chassis contains the Logix 5555 controller in
slot 1 and a 1756-ENBT bridge module in slot 3. We mounted the
1734-AENT adapter on a DIN rail in slot 0, with a 1734-OW2/C relay output
module in slot 1, a 1734-OV4E/C sink output module in slot 2, and a power
supply (not shown).
To work along with this example, set up your system as shown in the figure.
• Note that in the example application, the Logix5555 controller and
1756-ENBT module (firmware revision 2.3 or later) we assume are in
the slots shown in the figure.
• Verify the IP addresses for your programming terminal, 1756-ENBT
module, and 1734-AENT adapter.
• Verify the position (slot) of the I/O modules on the DIN rail.
• Verify that you properly connected all wiring and cabling.
• Be sure you configured your communication driver (such as
AB-ETHIP-1) in RSLinx software as described in Appendix A
Configure the RSLinx Ethernet Communication Driver on page 87 of
this manual.
Local
chassis
POINT I/O
Logix5555
controller (slot 1)
1756-ENBT
10.88.70.4 (slot 3)
Data
Switch
10.88.70.26
Programming
terminal
Slot 0 1 2 3
1734-AENT
10.88.70.2
Slot 0 1 2 3 4
31393-M