Rockwell Automation 1734-AENT POINT I/O EtherNet/IP Adapter Module User Manual
Point i/o ethernet/ip adapter module
Table of contents
Document Outline
- 1734-UM011D-EN-P POINT I/O EtherNet/IP Adapter Module User Manual
- Important User Information
- Preface
- Summary of Changes
- Chapter 1 - About the Adapter
- What This Chapter Contains
- Important Adapter Considerations
- Adapter Features
- Hardware/Software Compatibility
- What the Adapter Does
- Use of the Common Industrial Protocol (CIP)
- Understand the Producer/Consumer Model
- Specify the Requested Packet Interval (RPI)
- Support of Rack-optimized and Direct Connections
- Before You Begin
- Chapter 2 - Install the Adapter
- Chapter 3 - Configure the Adapter for Your EtherNet/IP Network
- Chapter 4 - Configure the Adapter for Direct Connection in RSLogix 5000 Software
- Chapter 5 - Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
- Chapter 6 - LED Status Indicators
- Appendix A - Adapter Web Pages
- Appendix B - Configure the RSLinx Ethernet Communication Driver
- Appendix C - POINT I/O Module and RSLogix 5000 Software Controller Tag Reference
- What This Appendix Contains
- 1734 POINT I/O Catalog Numbers
- Valid Number Ranges for RSLogix 5000 Data Types
- Digital 2 POINT Input
- Digital 4 POINT Input
- Digital 2 POINT Output – Without Diagnostic Status
- Digital 2 POINT Output – With Over Load and Open Load Diagnostic Status
- Digital 2 POINT Output – With Over Load Diagnostic Status
- Digital 4 POINT Output – With Over Load and Open Load Diagnostic Status
- Digital 4 POINT Output – With Over Load Diagnostic Status
- Analog 2 Channel Input
- Analog 2 Channel Output
- Specialty I/O
- Appendix D - Quick Start
- Index
- Back Cover