Rockwell Automation 1734-AENT POINT I/O EtherNet/IP Adapter Module - Manual (Page 31)

15 Publication 1734-UM011D-EN-P - May 2011
Chapter
3
Configure the Adapter for Your EtherNet/IP
Network
What This Chapter Contains
Before using your adapter in an EtherNet/IP network, configure it with an IP
address, subnet mask, and optional Gateway address. This chapter describes
these configuration requirements and the procedures for providing them. Here
are ways you can do this:
• Use the Rockwell BootP utility, version 2.3 or later, that ships with
RSLogix 5000 or RSLinx software.
You can also use this utility to reconfigure a device with an IP address
you must change.
• Use a third party DHCP server.
• Use the Network Address thumbwheel switch.
• Have your network administrator configure the adapter via the network
server.
See the table for a list of where to find information in this chapter.
Topic Page
Configuration Requirements 16
IP Address 17
Gateway Address 17
Subnet Mask 18
Set the Network Address 19
Use the Rockwell BootP/DHCP Utility 20
Save the Relation List 22
Use DHCP Software to Configure Your Adapter 23
ATTENTION
You must use series C POINT I/O modules with the
1734-AENT adapter. Series A or B POINT I/O modules will
not work with this adapter.