Brother MFC 4300 - Manual (Page 62)

6 - 3 S E T U P S E N D
3
Enter the fax number.
4
Press Start . The MFC starts scanning the original and the screen displays the
job number (#XX) of the fax, and how much memory is available. Then the
MFC starts dialing. You can immediately repeat Steps 1 through 4 for the next
fax.
Real Time Transmission
When you are sending a fax, the MFC will scan originals into memory before
sending. Then, as soon as the phone line is free, the MFC will start dialing and
sending the fax. If memory becomes full, the MFC will send the document in
real time, even if REAL TIME TX is set to OFF.
Sometimes you may want to send an important document immediately, without
waiting for memory transmission. You can set REAL TIME TX to ON.
1
Place the original face down in the ADF.
2
Press Function , 1 , 3 , 9 .
3
To change the default setting, press or
to select ON (or OFF), and then press
Set . Go to Step 5—OR—For the next fax
transmission only, press or to select NEXT FAX ONLY, and then press
Set .
4
For the next fax only, press or to select ON (or OFF), and then press Set .
5
Press 1 if you want to select additional settings. The LCD returns to the SETUP
SEND menu—OR—Press 2 if you are finished choosing settings, and then go
to Step 6.
6
Enter fax number, and then press Start .
Checking the Jobs Status
Check which jobs are still waiting in memory to be sent. (If no jobs are waiting,
the LCD shows NO JOB WAITING.) (See
Canceling Jobs in Memory , page 6-4.)
1
If the machine is idle,
Press
Function , 1 , 4 .
—OR—
If the machine is busy, go to step 2.
2
If you have multiple jobs waiting, use or to scroll through the list.
3
Press Stop to exit.
Note
Your MFC normally operates in Dual Access mode. However, you can
override Dual Access by using Real Time Transmission.
9.REAL TIME TX
REALTIME TX:ON?