Brother MFC 4300 - Manual (Page 45)

I N I T I A L S E T U P 4 - 4
Setting Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The default setting is LOW.
When the beeper is set to LOW or HIGH, the MFC beeps every time you press
a key or make an error, and at the end of fax sending or receiving.
1
Press Function , 1 , 1 , 3 .
2
Press or to select your setting, and then press Set .
3
Press Stop to exit.
Setting the Handset Volume
Before you begin to use the MFC, you must decide if you need to set the handset
volume to AMPLIFY:ON for a user who is hearing-impaired. The AMPLIFY
volume level complies with FCC standards.
VOLUME AMPLIFY: OFF
This default setting is appropriate if none of the users are hearing-impaired.
During a conversation, users can press
or on the control panel to adjust
the volume. When the handset is replaced, the handset volume remains until you
change it again.
VOLUME AMPLIFY: ON–TEMPORARY
This setting is appropriate if some of the users are hearing-impaired. During a
conversation, users can press
or on the control panel to adjust the volume
to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset
volume will return to the default setting of LOW.
VOLUME AMPLIFY:ON–PERMANENT
Choose VOL AMPLIFY:ON–PERMANENT if all of the users are hearing-
impaired. During a conversation, users can press
or on the control panel
to adjust the volume to LOW, HIGH or AMPLIFY. When the handset is
replaced, the handset volume returns to the default setting of AMPLIFY.
WARNING
It is important that you do NOT choose PERMANENT unless all users are
hearing-impaired. Otherwise, the default setting of AMPLIFY may damage
the hearing of some users.
When you press or on the control panel to adjust the volume, the display
shows the setting you are choosing. Each key press changes the volume to the
next setting.