Brother MFC 4300 - Manual (Page 46)

4 - 5 I N I T I A L S E T U P
Setting Volume Amplify
Please carefully read “Setting the Handset Volume” before you do the following
steps:
1
Press Function , 1 , 1 , 6 .
2
Press or to select
VOL AMPLIFY:OFF? if none of the users
are hearing-impaired, and then go to Step 4.
—OR—
If some or all of the users are hearing-
impaired, select VOL AMPLIFY:ON?.
3
If all the users are hearing-impaired, press
or to select PERMANENT?, and
then press Set.
—OR—
If only some of the users are hearing-impaired, select TEMPORARY?, and
then press
Set .
4
Press Stop to exit.
Setting the Speaker Volume
You can adjust the speaker volume of your MFC. First press Hook , then press
or to select a speaker volume level.
When you press or to adjust the volume level, the LCD shows the setting
you are choosing. Each key press changes the volume to the next level. The new
setting will remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your MFC is idle. You can turn the ring
off or you can select a ring volume level.
As you press or to adjust the volume level, the MFC rings so you can hear
the volume for the level shown on the LCD. Each key press changes the volume
to the next setting. The new setting will remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the INITIAL SETUP, SETUP
RECEIVE, SET AUTO DIAL, and REMOTE FAX OPT functions plus the
COVERPG SETUP and COVERPG MSG (from SETUP SEND) functions are
stored permanently. You may have to reset the date and time.
SELECT <- -> & SET
VOL AMPLIFY:OFF?
SELECT <- -> & SET
PERMANENT?