Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) - Manual (Page 72)

62 Brocade 6910 Ethernet Access Switch Diagnostic Guide
53-1002653-01
7
DRAFT: BROCADE CONFIDENTIAL
802.1x
Supplicant Parameters:
Identity Profile Username : steve
802.1X Port Summary
Port Type Operation Mode Control Mode Authorized
-------- ------------- -------------- ------------------ ----------
Eth 1/ 1 Disabled Single-Host Force-Authorized Yes
Eth 1/ 2 Disabled Single-Host Force-Authorized Yes
...
Eth 1/11 Disabled Single-Host Force-Authorized Yes
Eth 1/12 Enabled Single-Host Auto Yes
802.1X Port Details
802.1X Supplicant is disabled on port 1/1
...
802.1X Authenticator is enabled on port 12
Reauthentication : Enabled
Reauth Period : 3600
Quiet Period : 60
TX Period : 30
Supplicant Timeout : 30
Server Timeout : 10
Reauth Max Retries : 2
Max Request : 2
Operation Mode : Multi-host
Port Control : Auto
Intrusion Action : Block traffic
Supplicant : 00-e0-29-94-34-65
Authenticator PAE State Machine
State : Authenticated
Reauth Count : 0
Current Identifier : 3
Backend State Machine
State : Idle
Request Count : 0
Identifier(Server) : 2
Reauthentication State Machine
State : Initialize
show dot1x interface
Syntax: show dot1x interface ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
This command displays information about the 802.1x configuration on a specified port, as shown
in the following example.
Console# show dot1x interface ethernet 1/12
802.1X Authenticator is enabled on port 1/12
Reauthentication : Disabled
Reauth Period : 3600 seconds
Quiet Period : 60 seconds