Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) - Manual (Page 44)

34 Brocade 6910 Ethernet Access Switch Diagnostic Guide
53-1002653-01
4
DRAFT: BROCADE CONFIDENTIAL
Ethernet Ring Protection switching
Node State : Idle
West Port : Eth 1/ 1 (Blocking)
East Port : Eth 1/ 2 (Forwarding)
RPL Port : West
RPL Owner : Enabled
Holdoff Timer : 300 ms
Guard Timer : 300 ms
WTR Timer : 5 minutes
Control VLAN : 2
Propagate TC : Disabled
ERPS debug commands
debug erps
Syntax: debug erps {adm | opr | healthpdu} [domain domain-name]
• adm - Shows ERPS administrative status.
• opr - Shows ERPS operational status.
• healthpdu - Shows status of ERPS health PDUs.
• domain - Shows information for the specified ERPS ring.
• domain-name - Name of an ERPS ring. (Range: 1-12 characters)
The debug erps adm command shows the configuration settings for a ring.
Console#debug erps adm
{domain id/name (1/test)}
Adm:
A-TG A-TH A-TW EN LV VID PWEST PEAST RPL OWNER ROWS NODE-ID
500 0 300000 N 0 0 0 0 NONE N 3 001122-334455
MYID A-TE MAJOR SUB-NBR MEP1 MEP2 HLTH-POLL
1 300 0 0 0 0 N
{domain id/name (2/aaa)}
The debug erps opr command shows the operational status for a ring.
Console#debug erps opr
{domain id/name (1/test)}
Opr:
O-TG O-TH O-TW R-RAPS S-RAPS L-SF R-SF R-NR R-NRRB CUR-S RUNN TX-RAPS
0 0 0 0 0 0 0 0 0 0 N N
LST-RAPS BLK1 BLK2 DIRT1 DIRT2 SF1 SF2 TSF1 TSF2 O-TE BIT-PHY BIT-CCM
NR N N N N 0 0 0 0 0 1 2
{domain id/name (2/aaa)}
The debug erps healthpdu command shows the status of ERPS health PDUs.
Console#debug erps healthpdu
{domain id/name (2/aaa)}
Health PDU:
DSAP SSAP CTRL OUI TYPE SRC_LPORT SRC_PORT_MAC TX-HLTH RX-HLTH
0 0 0 000000 0000 0 000000-000000 0 0
{domain id/name (3/bbb)}