Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) - Manual (Page 46)

36 Brocade 6910 Ethernet Access Switch Diagnostic Guide
53-1002653-01
4
DRAFT: BROCADE CONFIDENTIAL
Connectivity Fault Management
Linktrace Cache Size : 100 entries
This example shows the configuration status for continuity check and cross-check traps.
Console# show ethernet cfm configuration traps
CC MEP Up Trap : Disabled
CC MEP Down Trap : Disabled
CC Configure Trap : Disabled
CC Loop Trap : Disabled
Cross Check MEP Unknown Trap : Disabled
Cross Check MEP Missing Trap : Disabled
Cross Check MA Up : Disabled
This example shows the CFM status for port 1.
Console #show ethernet cfm configuration interface ethernet 1/1
Ethernet 1/1 CFM Status:Enabled
This command displays configured maintenance domains.
show ethernet cfm md
Syntax: show ethernet cfm md [level level]
level – Maintenance level. (Range: 0-7)
This example shows all configured maintenance domains.
Console#show ethernet cfm md
MD Index MD Name Level MIP Creation Archive Hold Time (m.)
-------- -------------------- ----- ------------ ----------------------
1 rd 0 default 100
This command displays configured maintenance associations.
show ethernet cfm ma
Syntax: show ethernet cfm ma [level level]
level – Maintenance level. (Range: 0-7)
This example shows all configured maintenance associations.
Console# show ethernet cfm ma
MD Name MA Index MA Name Primary VID CC Interval MIP Creation
--------------- -------- --------------- ----------- ----------- ------------
steve 1 voip 1 4 Default
This command displays maintenance points configured on this device.
show ethernet cfm maintenance-points local
Syntax: show ethernet cfm maintenance-points local
{mep [domain domain-name | interface interface | level level-id] |
mip [domain domain-name | level level-id]}
mep – Displays only local maintenance end points.
mip – Displays only local maintenance intermediate points.
domain-name – Domain name. (Range: 1-43 alphanumeric characters)