Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) - Manual (Page 50)

40 Brocade 6910 Ethernet Access Switch Diagnostic Guide
53-1002653-01
4
DRAFT: BROCADE CONFIDENTIAL
Operation, Administration and Maintenance
This example displays counters for OAM PDU message types.
Console# show efm oam counters interface 1/1
Port OAMPDU Type TX RX
---- --------------------- ---------- ----------
1/1 Information 1121 1444
1/1 Event Notification 0 0
1/1 Loopback Control 1 0
1/1 Organization Specific 76 0
This command displays the OAM event log for the specified port(s) or for all ports that have logs.
show efm oam event-log interface
Syntax: show efm oam event-log interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port identifiers
with a comma and no spaces; use a hyphen to designate a range of ports. (Range: 1-12)
This example displays the OAM event log.
Console# show efm oam event-log interface 1/1
OAM event log of Eth 1/1:
00:24:07 2001/01/01
"Unit 1, Port 1: Dying Gasp at Remote"
This command displays the results of an OAM remote loopback test.
show efm oam remote-loopback interface
Syntax: show efm oam remote-loopback interface [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port identifiers
with a comma and no spaces; use a hyphen to designate a range of ports. (Range: 1-12)
This example displays the results of an OAM remote loopback test.
Console# show efm oam remote-loopback interface 1/1
Port OAM loopback Tx OAM loopback Rx Loss Rate
---- --------------- --------------- ---------
1/1 10000 9999 0.01 %
This command displays OAM configuration settings and event counters.
show efm oam status interface
Syntax: show efm oam status interface [interface-list] [brief]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate nonconsecutive port identifiers
with a comma and no spaces; use a hyphen to designate a range of ports. (Range: 1-12)