beautypg.com

Qos debug commands – Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) User Manual

Page 56

background image

46

Brocade 6910 Ethernet Access Switch Diagnostic Guide

53-1002653-01

5

DRAFT: BROCADE CONFIDENTIAL

QoS

Console# show qos map phb-queue interface ethernet 1/5

Information of Eth 1/5

PHB-queue map:

PHB: 0 1 2 3 4 5 6 7

-------------------------------------------------------

queue: 2 0 1 3 4 5 6 7

show queue mode

Syntax: show queue mode

This command shows the current queue mode.

Console# show queue mode

Queue Mode : Weighted Round Robin Mode

show queue weight

Syntax: show queue weight

This command displays the weights used for the weighted queues.

Console# show queue weight

Queue ID Weight

-------- ------

0 1

1 2

2 4

3 6

4 8

5 10

6 12

7 14

Console#

QoS debug commands

debug hardware dev-rm

Syntax: debug hardware dev-rm {dev-rm-om | meter-ref-table | meter-table | pcl-table |

rule-status}

dev-rm-om - Shows rule-managed device driver layer database.

meter-ref-table - Shows active meter configuration information.

meter-table - Shows all meter configuration information.

pcl-table - Shows Policy Control List configuration table.

rule-status - Shows the status of all rules.

The following command shows the status of all policy control entries.

Console#debug hardware dev-rm dev-rm-om

===========================

Dump DB - pces_use_status

===========================

0 ffffffff