beautypg.com

Acl and qos diagnostics, Acls, Acl show commands – Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) User Manual

Page 53: Common diagnostic scenarios, Chapter 5

background image

Brocade 6910 Ethernet Access Switch Diagnostic Guide

43

53-1002653-01

DRAFT: BROCADE CONFIDENTIAL

Chapter

5

ACL and QoS Diagnostics

In this chapter

This chapter provides diagnostic information for Access Control List (ACL) and Quality of Service
(QoS) environments, including traffic management.

ACLs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43

QoS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44

Traffic management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48

ACLs

Access Control List (ACL) show commands help users to diagnose and determine the cause of
faults for ACL-related features. For details on Layer 2 ACLs, refer to the Layer 2 ACL chapter in the
Brocade BR6910 Configuration Guide.

ACL show commands

show access-list

Syntax: show ip {standard | extended} access-list [acl-name]

show ipv6 {standard | extended} access-list [acl-name]
show mac ace ss-list [acl-name]

This command displays the ACLs configured on a Brocade device.

Enter the ACL name for the acl-name parameter to display a specific ACL, enter this command
without a name to display all configured ACLs for the specified ACL type, or enter the command
without specifying the ACL type or name to display all configured ACLs.

For a specific ACL, enter a command similar to the following example.

Console# show ip standard access-list david

IP standard access-list david:

permit host 10.1.1.21

permit 168.92.0.0 255.255.15.0

Common diagnostic scenarios

When an ACL was removed from a port with port mapping (ACL-based rate-limiting) configured,
the Brocade 6910 stopped all traffic on this port.
If you make an ACL configuration change, you must reapply the ACLs to their interfaces for the
change to take effect. An ACL configuration change includes any of the following actions:

-

Adding, changing, or removing an ACL or an entry in an ACL