Brocade 6910 Ethernet Access Switch Diagnostic Guide (Supporting R2.2.0.0) - Manual (Page 27)

Brocade 6910 Ethernet Access Switch Diagnostic Guide 17
53-1002653-01
3
DRAFT: BROCADE CONFIDENTIAL
Ethernet diagnostics
0 FCS Errors
0 Single Collision Frames
0 Multiple Collision Frames
0 SQE Test Errors
0 Deferred Transmissions
0 Late Collisions
0 Excessive Collisions
0 Pause Frames Output
===== RMON Stats =====
0 Drop Events
10305324 Octets
32060 Packets
270 Broadcast PKTS
9075 Multi-cast PKTS
0 Undersize PKTS
0 Oversize PKTS
0 Fragments
0 Internal Mac Transmit Errors
0 Internal Mac Receive Errors
0 Frames Too Long
0 Carrier Sense Errors
0 Symbol Errors
0 Pause Frames Input
show interfaces status ethernet
Syntax: show interfaces status ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
This command displays the operational status for Ethernet ports, as shown in the following
example.
Console# show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 1000BASE-T
MAC Address : 70-72-CF-32-DD-FE
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full, 1000full
Broadcast Storm : Enabled
Broadcast Storm Limit : 64 Kbits/second
Multicast Storm : Disabled
Multicast Storm Limit : 64 Kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 64 Kbits/second
Flow Control : Disabled
VLAN Trunking : Disabled
LACP : Disabled
Port Security : Disabled
Max MAC Count : 0
Port Security Action : None
Media Type : SFP preferred auto
Current Status:
Link Status : Up