Pre-strung beads, Multipurpose foot – Bernina dcet 2500 User Manual
Page 74

1999 BERNINA Of America
Section D - page 14
MULTIPURPOSE FOOT
P
RE
-S
TRUNG
B
EADS
Instruction
Manual pg.___
Feet-ures Unit ___pg.___
Serger Library – Specialty Stitches
Instruction Manual for Multi-purpose Attachment with Guide
•
Following the directions in the Instruction Manual on page___, thread for a
3-thread Flatlock using the Center Needle.
•
Turn the Stitch Selection Dial to “D”.
•
Set Stitch Length to 4.
•
Attach the Multi-Purpose Foot (no guide) following the directions in the Instruction
Manual for Multi-Purpose Attachment with Guide.
•
Attach the Right Hand Seam Guide and move the Guide halfway between the Right
Needle and the Stitch Finger.
•
Lay the pre-strung beads in the groove on the top of the Presser Foot, threading them
under the back groove (See Instruction Manual for Multi-purpose Attachment with
Guide).
•
Turn the Handwheel to encase the first beads into the Thread Chain.
•
Fold the fabric in half to 2” X 6” and place the fabric under the Presser Foot with the
fold against the Right Hand Seam Guide.
•
Slowly Flatlock the beads to the folded fabric.
•
Pull the fabric flat.
•
Trim and mount the sample.
FABRIC:
Medium weight fabric 4” X 6”
10” of plastic pre-strung beads (4mm)
NEEDLES:
80/12
Universal
THREAD:
3 cones of serger thread
PRESSER FOOT: Multi-Purpose Foot