Quilt-as-you-go – Bernina dcet 2500 User Manual
Page 28

1999 BERNINA Of America
Section B - page10
QUILT-AS-YOU-GO
Bernette
Advanced Guide Workbook Supplement pg.____
Serger Library – Simply Serging
•
Turn the Stitch Selection Dial to “A’ on the Stitch Selection Panel.
•
Thread the serger for a 4-thread Overlock stitch.
•
Attach the Right Hand Seam Guide and adjust for a ¼” seam.
•
Optional: Increase the Presser Foot Pressure to “H” for thick fabrics.
•
Create a quilt sandwich, layering the 4” fabrics as follows: 2 muslin (right sides
together), one layer of batting, 2 layers of printed fabric (right sides
together) and a layer of batting on top.
•
Raise the Presser Foot and position the fabrics under the Presser Foot with the
right edges of the fabric and batting butted against the Right Hand Seam Guide.
•
Lower the Presser Foot and touch the Needle Stop Button on the front (left)
of the serger to lower the Needles into the fabric.
•
Serge the 6 layers together, stopping as necessary to keep the right
edges of the fabrics even. (Hint: Use the Needle Stop Button to lower the
Needles and hold the fabrics in place while you align the right edges.)
•
Open the layers (1 muslin, 1 quilt top, 1 batting) to the right and left of the
serged seam and press flat.
•
To serge the third section into place, layer the remaining 4” fabrics as follows:
muslin to muslin, right sides together; print to print, right sides together;
batting on top.
•
Serge through all 6 layers.
•
Open the last 3 layers to the right side and press.
•
Add the last section to the top edge of the 3 paneled quilt. Layer the 5½”
fabrics as follows: muslin to muslin, right sides together; print to print, right
sides together; batting on top.
FABRIC:
4 pieces of contrasting print cotton fabric
cut 3 pieces 2” X 4” ; cut 1 piece 2” X 5 ½”
4 pieces of muslin
3 cut 2” X 4” ; 1 cut 2” X 5 ½”
4 pieces of cotton batting
3 cut 2” X 4”; 1 cut 2” X 5 ½”
NEEDLES:
80/12 Universal, Sharp, or Microtex
THREAD:
4 cones of serger thread
PRESSER FOOT: Standard