With digital input connector, Control cord connection for relay play, Setting the normal/dj switch (rear panel) – Pioneer DVJ-1000 User Manual
Page 20: Before operating (connections), When set to dj (dj mode), When set to normal (normal mode), Dvj-1000, En
Before Operating (Connections)
14
En
3. Connection to stereo amplifier (without DJ mixer)
4. Connection to component equipped with digital input connector
■ Setting the NORMAL/DJ switch (rear panel)
When the unit is used normally as a DJ DVD player, the mode select switch should be set to the “DJ” position. If the switch position
is changed during playback, playback will stop and after the stop, playback will begin from the beginning of the disc.
When set to DJ (DJ mode):
¶ During DVD playback, the digital output connectors produce 2-channel linear PCM digital data, regardless of the selected audio
signal format. In addition, subtitles and certain other functions and operations are not supported.
¶ During CD playback, the digital connector outputs only audio data without sub-codes. However, sampling frequency is fixed at 44.1
kHz. As a result, limitations of recording or other functions may be experienced when certain CD recorders or other components are
connected. For details, consult the Operating Instructions for the component to be connected.
¶ Some functions may be limited or disabled during DVD playback (☞ P.3, “About DVD playback in DJ mode”).
When set to NORMAL (NORMAL mode):
¶ The digital connector outputs digital data including sub-codes, but the player’s DJ functions are disabled.
¶ When unsupported operations are attempted the message “NORMAL” will appear in the display.
¶ When power is turned ON, if the NORMAL/DJ switch is set to “NORMAL”, the display shows the message “NORMAL”.
¶ If you wish to use all ordinary functions during DVD playback, set the unit to NORMAL mode (☞ P.3, “About DVD playback in DJ
mode”).
Connect CD or AUX input connector
(do not connect to PHONO input connector)
Accessory audio cable
Stereo amplifier
CD recorder or amplifier with
digital input connector, etc.
Coaxial digital cable
(sold separately)
2. Control cord connection for relay play
By using the accessory control cord to connect two DJ players, automatic relay play can be performed between the two units. (
☞ P.41)
DIGITAL
OUT
SYNC IN
COMPOSITE
DJ
NORMAL
AUDIO OUT
CONTROL
VIDEO OUT
R L
PREVIEW OUT
POWER
OFF
ON
AC IN
DIGITAL
OUT
SYNC IN
COMPOSITE
DJ
NORMAL
AUDIO OUT
CONTROL
VIDEO OUT
R L
PREVIEW OUT
POWER
OFF
ON
AC IN
S
S
S
S
DVJ-1000
DVJ-1000
Accessory control cord
DIGITAL
OUT
SYNC IN
COMPOSITE
DJ
NORMAL
AUDIO OUT
CONTROL
VIDEO OUT
R L
PREVIEW OUT
S
S
DVJ-1000
DIGITAL
OUT
SYNC IN
COMPOSITE
DJ
NORMAL
AUDIO OUT
CONTROL
VIDEO OUT
R L
PREVIEW OUT
S
S
DVJ-1000