Burnham MPC - Manual (Page 17)

17
A.
FACTORY ASSEMBLED SECTIONS - The
assemblage should be set in the proper location as
outlined in Section I. Lifting arrangement and weights
are given in Figures 4a and 4b.
Figure a: Lifting Instructions - Limited to thru 1 Section Block Assembly (No Steel Base)
Figure b: Lifting Instructions - thru 18 Section Block Assembly w/Steel Base
Number of
Sections
Length
A
(Inch)
Width
B
(Inch)
Height
C
(Inch)
Approx.
Center of
Gravity
D (Inch)
Approx.
Shipping
Weight
(Lbs.)
4 51½ 48 61½ 23¼ 2068
5 57½ 48 61½ 26¼ 2546
6 63½ 48 61½ 29¼ 3009
7 69¾ 48 61½ 32½ 3488
8 76 48 61½ 35½ 3952
9 82 48 61½ 38½ 4415
10 94¼ 48 61½` 44½ 4896
11 100½ 48 61½ 47¾ 5360
12 106½ 48 61½ 50¾ 5838
1. Do not Tilt. Exercise caution when lifting to avoid damage.
2. This boiler can be lifted by fork truck. Do not truck from front.
3. When lifting from rear, forks must extend from beyond center of gravity and second skid cross bar.
4. When lifting from side, forks must extend to opposite skid rail and straddle center of gravity.
5. Cablespreader is to prevent casting damage. Spreader width should equal B (width of skid) +12”.
Adjust cable lengths to lift at approximate center of gravity per chart.
SECTION II - CAST IRON BLOCK ASSEMBLY INSTRUCTIONS
(Knockdown Boilers)
Number of
Sections
Lifting
Weight
(lbs)
Lift Locations
Hooks 1 & 2 Hooks 3 & 4
4 1875 Front Rear
5 2321 Front Rear
6 2767 Front Rear
7 3213 Front Rear
8 3659 Front Rear
9 4105 Section 2 Rear
10 4551 Section 2 Section 9
11 4997 Section 3 Section 10
12 5443 Section 3 Section 10
Number of
Sections
Length
A
(Inch)
Width
B
(Inch)
Height
C
(Inch)
Approx.
Center of
Gravity
D (Inch)
Approx.
Shipping
Weight
(Lbs.)
13 112½ 48 61½ 53¾ 6301
14 118¾ 48½ 63½ 57 6805
15 125 48½ 63½ 60 7270
16 131 48½ 63½ 63 7734
17 137 48½ 63½ 66 8199
18 143¼ 48½ 63½ 69¼ 8663
Optional Steel Shipping Base - thru 1 Section Block
Standard Steel Shipping Base - 1 thru 18 Section Block
NOTE: Only factory packaged and firetested units are eligible to bear the UL listing mark.