Konica Minolta bizhub 181 - Manual (Page 302)

Troubleshooting 8
bizhub 181 8-3
Tro
uble
s
hoo
tin
g
Chapter 8
The edge of the copy is
dirty. Is the document pad dirty? Clean the document pad with a
soft cloth dampened with a mild
detergent. (See page 9-8.)
Was the selected paper size
larger than the document?
(when copying at full size) Select a paper size that is the
same size as the document. (See
page 4-12.)
Otherwise, select the “AUTO”
Zoom setting to enlarge the copy
to the selected paper size. (See
page 4-52.)
Are the document size and paper
orientation different?
(when copying at full size) Select a paper size that is the
same size as the document. Oth-
erwise, select a paper orientation
that is the same as that of the
document.
Was the copy reduced to a size
smaller than the paper?
(when copying at a reduced size
specified manually) Select a zoom ratio that adjusts
the document size to the select-
ed paper size. (See page 4-53.)
Otherwise, select the “AUTO”
Zoom setting to reduce the copy
to the selected paper size. (See
page 4-52.)
The image is not aligned
properly on the paper. Is the document incorrectly posi-
tioned? Correctly position the document
against the document scales.
(See page 3-20.)
If the document feeder is in-
stalled, correctly adjust the doc-
ument guides for the size of the
document. (See page 3-18.)
Is the document incorrectly posi-
tioned in the document feeder? Lift open the document feeder,
and correctly position the docu-
ment against the document
scales. (See page 3-20.)
Are the adjustable document
guides incorrectly positioned
against the edges of the docu-
ment? Slide the document guides
against the edges of the docu-
ment.
Was curled paper loaded into the
paper drawer? Flatten the paper before loading
it into the paper drawer.
Symptom Possible Cause Remedy