Konica Minolta bizhub 181 - Manual (Page 106)

Making copies 4
bizhub 181 4-13
Making
co
pies
Chapter 4
!
Detail
If “NO SUITABLE PAPER” appears in the display after “AUTO” is
selected and the [Start] key is pressed, no paper tray or drawer is loaded
with paper of the most suitable size. Either load paper with the
appropriate size, or select a paper drawer, and then press the [Start] key
again.
Automatic tray switching feature
With the automatic tray switching feature, copying/printing can continue with
paper from a different paper drawer if the currently selected drawer runs out
of paper during copying/printing.
The automatic tray switching operation is performed if the currently selected
paper drawer and another paper drawer (other than the manual bypass tray)
meet the following conditions.
-
The paper loaded in the paper drawer is the same size.
- The paper loaded in the paper drawer is the same type.
- The paper loaded in the paper drawer is in the same orientation.
- Either “PLAIN” or “RECYCLE” is selected for the type of paper loaded in
each paper drawer.
!
Detail
If paper is loaded into the manual bypass tray, the automatic tray switch-
ing operation is not performed.
If the optional multi bypass tray, 2nd paper drawer, 3rd paper drawer, 4th
paper drawer and 5th paper drawer are installed, a maximum of 1,350
pages can be continuously copied/printed. When continuously copying/
printing a large number of pages, load all paper drawers (except the man-
ual bypass tray) with paper meeting the conditions listed above.
If there is no paper in any paper drawer, a message appears indicating
that paper must be replenished. Copying/printing may not continue if pa-
per is loaded into other paper drawers than the one specified in the mes-
sage.