Konica Minolta bizhub 500 - Manual (Page 56)

Scanning Documents 2
bizhub 500/420 2-21
Scan
nin
g
Do
cu
men
ts
Chapter 2
– For details on the scan settings, refer to “Specifying the Scan Set-
tings” on page 2-43.
4
After specifying the settings, touch [OK].
5
Load the document into the ADF or position it on the original glass of
the machine.
6
Press the [Start] key on the control panel.
The document is scanned, and the data is sent.
2
Note
Do not turn off the machine until the scanned jobs disappear from the job
list.
Selecting Group Addresses
“Group” refers to multiple destinations that are registered collectively. The
following procedure describes how to send data by selecting a group that
has been registered in advance.
For details on registering groups, refer to “Registering Group Destinations”
on page 3-22.