Konica Minolta bizhub 500 - Manual (Page 303)

4 Specifying Settings Using PageScope Web Connection
4-32 bizhub 500/420
Spe
c
if
ying
Set
ti
ng
s Usin
g Pag
e
Scope
We
b Co
nne
ctio
n
Chapter 4
When “Group: Scan” is selected
Item Description
No. Enter the registration number.
Name Enter the registration name (up to 24 characters).
Group Click , and then select a group destination from the list to
display the group number.
Resolution Select the resolution.
File Type Select the file format.
Scan Setting Select the unit of the data to be saved.
Subject Specify the subject (Not Specified, 1 to 10). When “Not Spec-
ified” was selected, the default title is used. Click
to check
the contents.
Text Specify the text (Not Specified, 1 to 10). When “Not Specified”
was selected, the default text is used. Click
to check the
contents.
Simplex/Duplex Select “1-Sided”, “2-Sided”, or “Cover + 2-Sided”.
Original Type Select the quality of the original such as text or photo.
Separate Scan Select “ON” or “OFF”.
Density Adjust the density.
Zoom Select the enlargement or reduction ratio for scanning. Select
a preset zoom ratio or specify separate ratios for the X and Y
directions.
Scan Size Select the original size (“Auto”, “Standard Size”, “Custom
Size”).
For “Custom Size”, specify the horizontal and vertical
scanning sizes.
E-Mail Notification The upload destination of the file can be notified to the spec-
ified address.
Destination Click to select the notification addresses.
File Name Enter the file name (up to 30 characters).
Original Direction Select the orientation of the original document.
Bind Select the original binding position.
Special Original Select whether the document contains mixed page sizes or is
Z-folded.
Book Scanning Select whether or not to enable book scanning. If “ON” is
selected, the scanning method and binding position are
specified.
Booklet Pagination Select whether or not to enable page scanning. If “ON” is
selected, the binding position is specified.
Erase Specify the width of the perimeter of the document to be
erased.
Center Erase Specify the width of the area along the binding that is to be
erased.