Konica Minolta Fujitsu Scanner - Manual (Page 307)

●AP-13
■ Alarm message (Hardware error
:Check LED illuminated
)
The following messages are displayed, when an error occurs inside the sccaner. In this case,
please switch on the power supply once again after disconnecting the power supply.
If the same message is displayed again, please contact a distributor or an nearest imaging service
and support center for help.
(Front side) The following message is displayed, when an error occurs to the
front side optical unit.
(Back side) The following message is displayed, when an error occurs to the
back side optical unit.
(Toransport motor) The following messages are displayed, when the fuse of various
motors (Toransport motor, Separation motor, Pick motor, Hopper
motor) goes out.
(Separation motor)
(Pick motor)
(Hopper motor)
p c a i O t l A l r m a
F o r n d e i t S
p c a i O t l A l r m a
B c a k d e i S
F d e e m o t r o
F s u e a l r m a
p S a r e a i o t n
F s u e a l r m a
m o t r o
P k c i m o t r o
F s u e a l r m a
m o t r o
F s u e a l r m a
H p r e o p