Lenovo ThinkPad Edge 15 - Manual (Page 85)

• Perform a silent installation of the Rescue and Recovery programwithout a reboot at the end.
• Start the Rescue and Recovery program so that a base backup can be performed.
• After the service is started, set up the environment to create an ISO image of the Rescue and
Recovery CD (this is normally performed as part of a reboot).
• Create the ISO image.
• Create the base backup and reboot the system.
5. Modify the install.cmd code. The following represents the code for install.cmd:
:: Copy custom rnrdeploy.xml here
copy rnrdeploy.xml "c:\RRTemp\Program Files\Lenovo\Rescue and Recovery"
:: Install using the MSI with no reboot (Remove "REBOOT="R"" to force a reboot)
start /WAIT msiexec /i "c:\RRTemp\Rescue and Recovery.msi" /qn REBOOT="R"
:: Start the service. This is needed to create a base backup.
start /WAIT net start "Rescue and Recovery Service"
:: Make an ISO file here - ISO will reside in c:\Program Files\Lenovo\Rescue and
Recovery\rrcd
Note: You do not need to set up the environment if the system is rebooted.
:: Set up the environment
set PATH=%SystemDrive%\Program Files\Common Files\Lenovo\Python24
set PATHEXT=.PYW;.PYO;.PYC;.PY
set TCL_LIBRARY=%SystemDrive%\Program Files\Common Files\Lenovo\Python24
\tcl\tcl8.4
set TK_LIBRARY=%SystemDrive%\Program Files\Common Files\Lenovo\Python24
\tcl\tk8.4
set PYTHONCASEOK=1
set RR=C:\Program Files\Lenovo\Rescue and Recovery\
set PYTHONPATH="C:\Program Files\Common Files\Lenovo\Python24"
:: The next line will create the ISO silently and not burn it
Chapter 5 . Best practices 77