Lenovo ThinkPad Edge 15 - Manual (Page 114)

Table 36. Computer Configuration>Rescue and Recovery>Settings (continued)
Policy Setting Sub-Setting Description
Backup Backup Network Enable or disable Backup Network
as selected destination for backup.
Default: Disabled.
Notes:
1. If the performance of backing
up the service partition fails due
to insufficient space, manually
delete the partially finished
backup before attempting
to create another backup or
restoring from the failed backup.
2. When backing up the service
partition to external media, set
the following registry key before
restoring your system with
Rescue and Recovery:
HKLM\Software\Lenovo\
Rescue and Recovery\
Settings\Backup\
BackupSPNetwork=1
Backup Local Partition
Number Set the partition number for backups
on the local drive. Valid values:
1-100. Default: 1.
Backup USB Partition
Number Set the partition number for backups
on the USB drive. Valid values:
1-100. Default: 1.
Backup Second HDD
Partition Number Set the partition number for backups
on the Second hard disk drive. Valid
values: 1-100. Default: 1.
Backup Backup Partitions Select the partitions that should
be backed up. This DWORD is
a bitmap of logical drive letters
that should be included in the
backup.To get the right hexadecimal
value for drive letters, lay out the
drive letters from right to left (for
example, …HGFEDCBA), and put
1 for partitions that will be backed
up.Example: If you back up drive c:
and e: only, you will get the binary
value 00010100. The hexadecimal
value for it: 0x00000014 and the
decimal value for it: 20.Note:
Convert your hexadecimal number
to decimal before entering. Default:
0xFFFFFFFF. Entering a zero has a
meaning similar to the default, which
means finding all available partitions
and back them up.
Backup Max Backup Size Set the maximum backup size.
Valid values: 1-1000 (GB). Default:
available free space.
106 Rescue and Recovery 4.23 Deployment Guide