Lenovo ThinkPad Edge 15 - Manual (Page 57)

net start dhcp
net start nla
7. Put the NETSTART.TBI file under the \SWWORK directory and the SYSTEM32 winbom.ini file under
the \MININT directory back by using the RRUTIL process described in “Using the RRUTIL.EXE utility”
on page 31.
Note: The default environment supports only the DHCP environment.
The following table provides the entry and description for IP configurations:
Table 21. Static IP address entries
Entry Description
Gateway Specifies the IP address of an IP router. Configuring a default gateway creates a
default route in the IP routing table. Syntax:
Gateway = xxx.xxx.xxx.xxx
IPConfig Specifies the IP address that Windows PE uses to connect to a network.
Syntax:IPConfig = xxx.xxx.xxx.xxx
StartNet
Specifies whether to start networking services. Syntax:StartNet = Yes | No
SubnetMask Specifies a 32-bit value that enables the recipient of IP packets to distinguish
the network ID and host ID portions of the IP address. Syntax:SubnetMask =
xxx.xxx.xxx.xxx
Changing the video resolution
You can change the video resolution by changing the default Predesktop Area resolution settings of 800 Ч
600 Ч 16-bit. To change the settings, complete the following procedures:
1. Get the \MININT\SYSTEM32\WINBOM.INI file by using the RRUTIL process described in “Using the
RRUTIL.EXE utility” on page 31.
2. Open the file for editing.
3. Add the following entries:
[ComputerSettings]
DisplayResolution=800x600x16 or 1024x768x16
When the Rescue and Recovery environment starts, you see an additional window during startup that is
titled “Factory preinstallation”. The colors are reduced from thousands to 256.
4. Put back the \MININT\SYSTEM32\WINBOM.INI file by using the RRUTIL process described in “Using
the RRUTIL.EXE utility” on page 31.
Startup applications
The Rescue and Recovery Windows PE environment supports startup scripts, programs, and customized
programs. These scripts or programs will be processed before the Rescue and Recovery Windows PE
environment reaches the main PE interface page.
The directory to place the scripts or programs is \Preboot\Startup. Scripts or programs in this directory are
processed alphanumerically. For example, a script called a.bat would be processed before 1.exe.
Chapter 3 . Configurations 49